Antweight brushless motor and esc for an ant spinner?
Author
Thread
miles&Jules Experienced Roboteer
Joined: 19 May 2010
Posts: 3973
Location: ipswich QLD
Antweight brushless motor and esc for an ant spinner?
Hi All
So whats a good place to start for an ant weight brushless motor and esc for a spinning ant weight?...my budget is $30 ish...so bottom of the barrel will do.
i'm thinking that might be the way to make some progress with my next ant.he he
Just thinking of how I would build a drum, but probably won't do it. _________________ So even the rain that falls isn't actually going to fill our dams and our river systems
what about embedding a bearing into the support on the far end. It would probably be an easier option than trying to put it into the bell unless you wanted to turn a custom bell and glue in magnets I really don't think its possible.
You could replace the shaft with a longer one and then just add a small bearing in the support on the other end. Or even turn down the bit where the prop is meant to mount and put a bearing over that.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum