|
|
|
|
|
|
|
maddox
Joined: 21 Dec 2006
Posts: 786
Location: Belgium
|
Dortmund modelbuilders fair 2019.
Dortmund 2019.
Perun did well actualy, only 1 failure in the weekend. A motorcan unscrewing itself from the front plate.
The fact the machine isn't very aggressive and the driver, Babeth, is learning to cope with the new drives in combat situations, made the ranking not as high as some would like.
Upgrades? Replacing the scoop and some wheel protection seem right.
Nebelwerfer4 shows maturation. The 2 failures. A broken belt and a lose weaponmotor wire can be traced to me, not the inherent machine, what came trough with only some scrapes, dents or otherwise cosmetic issues.
With a load of spare armor parts in our toolbox, non have been used, and won't be needed.
Upgrades? With 500 grams+ in reserve, we can do a lot. But the main thing will be cleaning up the wiring and simplifiying maintenance. I doubt weaponpower needs an increase.
Kashei is dead. The weapon keeps destroying itself. We're designing a new version, but first we'll experiment with slip clutches.
|
Sat Apr 13, 2019 6:50 am |
|
|
|
maddox
Joined: 21 Dec 2006
Posts: 786
Location: Belgium
|
After Dortmund Life had other plans for Team RCC.
But with Hannover comming up, we got together and started on Nebelwerfer earlier this evening.
Armor looks chewed, but isn't weakened. So, we're still running the original parts. We'll replace the stickers tough. And maybe add some extra .
The disk. Bushings are cracked and running on Ti is wearing them out faster than expected. So, we installed the spare disk, and the old one is getting new bushings later this weekend, becoming the spare. Try that with bearings, 4 events , and still working.
Frame. 6mm Ti. Nothing to see, repair or replace.
Electronics. Replaced some gaffatape labels and connector taping. Tested the whole, and we declare Nebelwerfer 4 ready.
Perun will go on the table tomorrow.
|
Sun Jul 28, 2019 7:23 am |
|
|
|
|
|
|