Wheapon/s drive system:300 psi compresor motor coupled to angle grinder gear box with circular saw blade
2nd wheapon: Small high speed drum in wedge
Speed/motor control:IBC
Power: 2x2.3amp 12volt sla's in parralel
Armour:3mm+5mm ali +12mm rubber conveyor belting
Length Width Height 450mm x300mmx100mm
Type of radio controler: Skyport
Radio frequancy:( eg,36mgz)
General coments :Very fast unpredictable
Unuasual charatistics: Wheel stands on take off and does nice 360s
No, of Fights:
Wins :
Losses:
Link to picture in photo albulm:
The cheese had its broken motorand gear box replaced today and its ready to mount back in the chasis.Hopefully i will get that done tommorow.
Last edited by Totaly_Recycled on Tue Dec 13, 2005 1:54 pm; edited 1 time in total
Wed May 18, 2005 11:19 pm
Mel Site Admin
Joined: 21 Dec 2004
Posts: 163
Location: Victoria
Very nice _________________ It's a She Thing
Thu May 19, 2005 12:27 am
Totaly_Recycled Experienced Roboteer
Joined: 15 Jun 2004
Posts: 1346
As its a no spinner event the cheese has its saw removed so it will be a lot easier to drive with out all the weight hanging off the back..its got a bit of 4x2 pine bolted on instead to give a bit of aerial protection . Hopefully i wil get some pics up of these bots soon so i can link them into all the Stats forms .
Fri May 20, 2005 10:10 pm
Totaly_Recycled Experienced Roboteer
Joined: 15 Jun 2004
Posts: 1346
We havent done much with this robot for a while as Stewart lost interest in driveing for a while (he hate's sirtting in the car for 3 hours to the events )
He told me that he wants to drive it at robo wars .At the moment its completly striped out ready to put in its new wheapon the big saw is disaperaing of the back as it counter balances the robot and makes it hard to steer and it pops wheelis al the time which isnt good for a wedge .Its now geting a low profile wheapon which should give it better ballance .I just have to shift every thing around to make it fit .
Well the wheapon is comeing along nicely almost have it fitted in the bot i mounted a compresor motor on it this morning and just have to make mounting blocks for the bearings and motor now ..might just cast them all out of fiberglass and resin mix . i might take out the drive motors and give them a mod while im at it as the cheese runs big dia wheels .
Wed Dec 07, 2005 1:24 pm
Totaly_Recycled Experienced Roboteer
Joined: 15 Jun 2004
Posts: 1346
The wheapon is finished and is going i havent tested it on any thing while in bot as yet might just leave that part for Stewart at an event i need to do some work to the drives to make it go in a straight line but it will do for now until i get arouind to completly fixing both drive mounts properrly .stewart will just need to learn to drive it with out the saw and to make sure he lines the wedge up for atacking. The new wheapon is mounted in the center of wedge and is also invertable.
Sat Dec 10, 2005 1:26 pm
Totaly_Recycled Experienced Roboteer
Joined: 15 Jun 2004
Posts: 1346
I gave the cheese schreder a bit of a run aat HOC on sunday i think a few people were impresed i curently have the 40 channel stufed radio in it so it had the jitters and dint drive unless i was close .... but no one else put their bots in the arena to test while i was running it
Tue Dec 13, 2005 1:46 pm
Knightrous Site Admin
Joined: 15 Jun 2004
Posts: 8511
Location: NSW
We still going to change the gearing? Or leave it where it is? I want to see it do things faster 12K or 20K sounds fast enough? _________________ https://www.halfdonethings.com/
Tue Dec 13, 2005 2:40 pm
Totaly_Recycled Experienced Roboteer
Joined: 15 Jun 2004
Posts: 1346
the cheese is prety well ready to go i might add a bit more armour if i get the time as this robot is still under 11kgs This robot should be ready for robo wars as well
Wed Dec 28, 2005 1:56 pm
Totaly_Recycled Experienced Roboteer
Joined: 15 Jun 2004
Posts: 1346
I still have a few litle things to do on this one like add a bit more 1.5 mm stainles steel for armour but as is, its still ready to battle.
Sat Dec 31, 2005 10:41 am
Totaly_Recycled Experienced Roboteer
Joined: 15 Jun 2004
Posts: 1346
Radio problems are still hounding this robot although i turned it on this afternoon and gave it a drive and no glitches what so ever so what ever is doing it is an intermitat problem and gets worse as i drive it so might change the transmiter bateries when i get some fresh ones on town they have been in there since the last robo wars
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum