Well I collected my beater "blanks" yesterday and it's not looking good.
The "laser" cutting looks like it was plasma cut instead and its pretty rough, if I am some how able to machine these blanks to spin, it's going to require a hell of a lot of work to balance them.
Joined: 19 May 2010
Posts: 3973
Location: ipswich QLD
Dont ya have to make a pulley anyway for the belt to spin it.....then just shove another pulley at the other end to...we wont mind if its a bit wobbly he he _________________ Miles Blow - Julie Pitts
www.mulesfilm.com.au www.wombokforest.com.au
-Pickasso- Vivid Sportsman champion 2015
Mon Sep 16, 2013 11:47 am
Knightrous Site Admin
Joined: 15 Jun 2004
Posts: 8511
Location: NSW
Will fit the 4 jaw chuck to the lathe tonight and have a go at setting it up in the lathe for machining. _________________ https://www.halfdonethings.com/
Mon Sep 16, 2013 1:30 pm
Glen Experienced Roboteer
Joined: 16 Jun 2004
Posts: 9481
Location: Where you least expect
if its been cut by any heat method remember to grind off the HAZ before trying to machine it. _________________ Mechanical engineers build weapons, civil engineers build targets
wow. that's... not ideal _________________ <Patrician|Away> what does your robot do, sam
<bovril> it collects data about the surrounding environment, then discards it and drives into walls
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum