I bought a Turnigy Reciever controlled switch, and i wired my full robots system up. Thing is, whenever i test the failsafe, the switch goes to the on position and turns my solenoid on which in turn fires my ram and wont close until signal is returned. I played with the failsafe jumpers and it seems that it only failsafes the start. Ex: putting failsafe to off pos - reciever connecting to trans and dosent do anything. If I turned the trans off, the fires. I need help.

Heres the manual for the switch,
http://www.hobbyking.com/hobbyking/store/uploads/907097217X46219X9.jpg
_________________
Viggy!
1st Robot in progress!

Prolly not much you can do. Buy a better switch.... You sure you got jumper set up correctly? I am assuming Mode II failsafe should be what it is.
_________________
Steven Martin
Twisted Constructions
http://www.botbitz.com

Like these:

http://dimensionengineering.com/PicoSwitch.htm
http://dimensionengineering.com/BattleSwitch.htm
_________________
https://www.halfdonethings.com/

Yeah mode 2 or 3 would do what you want depending on what solenoid your using (normally open or normally closed).
_________________
www.demon50s.com - Minimoto parts
http://www.youtube.com/user/HyzerGlen - Videoooozzz

Or can program you up a Plush10 if you wnat.
_________________
Steven Martin
Twisted Constructions
http://www.botbitz.com

All fixed. Seems that it needed to be plugged into a port for a toggle switch. All failsafes now
_________________
Viggy!
1st Robot in progress!

So your receiver was failsafing the throttle channel for you?
_________________
Steven Martin
Twisted Constructions
http://www.botbitz.com

Oh yea, didnt think of that. Yea it was. Maybe i can disable the setting inside the system but i actually like it with a toggle.
_________________
Viggy!
1st Robot in progress!