Joined: 16 Jun 2004
Posts: 9481
Location: Where you least expect
hammer lok table
was unsure whether to put this in the off topic or general section, but ill whack it here for now.
i just got one of those big huge hammerlok work tables that uses a series of tabs that hammer into slots in the upright pieces. ive put it together but its still as flimsy as hell.
i cant seem to hammer the tabs in any farther without destroyed the frame. has anyone come across these tables before? i cant find a dang thing on google about them. _________________ www.demon50s.com - Minimoto parts
http://www.youtube.com/user/HyzerGlen - Videoooozzz
Sat Nov 20, 2004 7:36 pm
Windhammer
Joined: 19 Jun 2004
Posts: 338
Location: Roleystone WA
ahhh today i put together one of them.
have you made sure the tabs are not sticking out the sides and have gone all the way into the slots? but generaly they are quite flimsy and crapy and wobble around.
Sat Nov 20, 2004 8:17 pm
Glen Experienced Roboteer
Joined: 16 Jun 2004
Posts: 9481
Location: Where you least expect
my tabs are sticking our the sides but dont go through all the way.. everytime i try hitting it with a hammer it just dont budge. the thin part goes in but the chunkier part wont..
Joined: 19 Jun 2004
Posts: 338
Location: Roleystone WA
how much did it cost you?
Sat Nov 20, 2004 9:27 pm
Forum Jump:
Page 1 of 1
Forum Rules:
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum